TPM value in frying oil: meaning, limit, measurement

TPM stands for total polar materials, also called polar compounds. The value shows, as a percentage, how far a frying oil has broken down through use. In Austria, the Austrian Food Code names 27 % polar compounds as a sign that a frying fat is spoiled. The oil is changed at that point at the latest.

What are polar compounds?

Fresh frying oil consists almost entirely of fat molecules. During frying, heat and oxygen from the air act on the oil. This produces breakdown products that specialists group together as polar compounds. The longer and the hotter an oil is used, the higher their share rises.

This makes the TPM value the most common measure of the condition of frying oil. It tells you more than the colour or the number of days in use, because it measures the change in the oil itself.

Which limit applies in Austria?

The reference is the Austrian Food Code (Österreichisches Lebensmittelbuch), chapter B 30, section 1.7.3. It lists several signs that a frying fat has already changed:

  • 27 % polar compounds
  • more than 12 % polymeric triglycerides
  • significant defects in smell or taste
  • blue-grey smoke at 180 °C
  • persistent, thick foam when food is added to the oil
  • darkening and a change in consistency
  • significant amounts of charred residue

The Food Code is not a law. Food inspectors do, however, use it together with the Austrian Food Safety and Consumer Protection Act when assessing samples. In a 2019 inspection campaign, the Austrian Agency for Health and Food Safety (AGES) examined 79 samples of frying fats in use. 20 of them were judged unfit for human consumption.

Austria and Germany compared

CountryValue for polar compoundsBasis
Austria27 %Austrian Food Code, chapter B 30
Germany24 %Recommendation of the German Society for Fat Science (DGF), applied by food inspection authorities

If you work to German requirements, for example in a group with uniform standards, follow the stricter value.

How is the TPM value measured?

In the kitchen you measure with an electronic frying oil tester. The probe is held in the hot oil and the device shows the value as a percentage. Proceed as follows:

  1. Always measure at the same time, ideally before service starts.
  2. Measure in hot oil with no food in the fryer. Follow the instructions for your device.
  3. Note the date, the fryer and the value. This shows you how fast the value rises.
  4. Change the oil before the limit is reached.

Paper test strips measure free fatty acids, not the TPM value. They give an indication but do not replace a TPM measurement. In the laboratory, polar compounds are determined with standardised methods. The authority relies on these when it takes a sample.

Which value is good in daily use?

Our instructions for the filter pads give 8 to 18 % TPM as the ideal range. This range leaves enough distance to the limit. What matters is that the value rises only a little from day to day.

How to keep the TPM value low for longer

The value rises more slowly when the temperature is right, little water and salt get into the oil, and residue is removed every day. You will find the individual steps in the guide Making frying oil last longer.

You can also bind polar compounds out of the oil every day. This is what Solfina filter pads with Magnesol and Magnesol powder for large oil volumes are for. Read how this works under How Magnesol works. If your value rises too fast despite good care, see Frying problems.

Questions? Write to us at office@solfina.at or call +43 664 521 41 80.